|
1. Remove a cover at the basis of a manual brake and turn away an adjusting nut of a cable (nuts of the left and right cables are noted), which also крепит a cable to the lever of a manual brake. There are two cables – on one on each back wheel, and a nut for each cable. On some cars for access to nuts it is necessary to remove the central section (tray). |
| 2. Lift a back part of the car and establish on supports. |
| 3. Remove a brake drum, or a brake disk. |
| 4. On cars equipped with back drum-type brakes, disconnect a cable of a manual brake from the lever back колодки. On cars with back disk brakes remove brake колодки and a drive колодок (subsection 10.4 see), then disconnect a cable of a manual brake from a drive. |
|
|
| 5. To disconnect a cable from a drive on back дисковы brakes submit on itself external эксентрик and remove a pin which крепит a cable to the internal clown, remove internal эксентрик. |
| 6. On cars equipped with back drum-type brakes, take a cable, its cover from an underside of a board of a brake, then get a cover of a cable from скоб on the suspension bracket lever (to straighten it and to facilitate протягивание a new cable). On cars with back disk brakes it is not obligatory to take a cover of a cable from a brake board, it is enough to get of it from скоб on the lever of a back suspension bracket. |
|
7. Extend a cable from a cover from outside wheels. |
| 8. Grease a new cable консистентной with greasing and enter it into a cover. Stretch a cable through a cover to the drive lever колодки. |
| 9. Establish a cover in a brake board, and attach a cable tip to the drive lever колодки (back drum-type brakes) or to эксцентриковому to the sliding device (back disk brakes). Be convinced after joining on a cable there are no bent sites. |
| 10. Fix a cable cover in скобах on the lever of a back suspension bracket. |
| 11. On cars equipped with back drum-type brakes, establish brake колодки and a drum. On cars with back disk brakes establish колодки a manual brake and эксцентриковое the sliding device колодок, and also a back disk of a brake. |
| 12. Lower the car and wrap an adjusting nut on a tip of a cable of a manual brake. Adjust a cable of a manual brake and establish a dustproof cover. |