BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
1. Lift the car.
2. If the stabilizer varies or it is necessary to replace a suspension bracket rack disconnect a cross-beam of the stabilizer from its racks: turn away a nut of fastening of a cross-beam of the stabilizer to the top part of a rack (the top arrow). In the event that the suspension bracket lever varies, turn away a nut (the bottom arrow) and disconnect from the lever a stabilizer rack in gathering and an arm.
3. Turn away bolts and disconnect an arm of the plug from a body.
4. Turn away bolts of fastening of arms of plugs of the stabilizer to a suspension bracket cross-beam.
5. Remove the stabilizer. If necessary disconnect the stabilizer from an arm on a suspension bracket rack.
6. Installation is carried out upside-down. All connections tighten with the moments specified in section 11.1.2.