BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.1.8. A nave of a forward wheel and the bearing
THE GENERAL DATA

The prevention

After removal knot a nave / the bearing becomes unsuitable to the further operation and its replacement is required.


Removal and installation

PERFORMANCE ORDER
1. Release wheel bolts, lift redock of the car and remove a wheel.
2. Bring down a nave cap.
3. Расконтрите a nave nut, having straightened the pressed part of a fillet.
4. Establish a wheel and lower the car. Release a nave nut (but do not turn on completely).

The prevention

Nave nut it is necessary to turn on to (tighten) when the car is removed from a jack.


5. Again lift the car and remove a wheel.
6. Remove a support of a brake and an arm (subsection 10.6 see), take aside and fix, without supposing повисания on a brake hose.
7. Remove a brake disk (subsection 10.6 see).
8. Turn away a nut of a nave and remove a nave in gathering with подшипникамис pins, if necessary displace a nave hammer blows.

9. If on a pin there will be an internal holder of the bearing remove грязеотражатель (a rubber cover) and a stripper press a holder.
10. Replace a rubber cover of the bearing.

11. Establish a new nave, if necessary напрессуйте a nave through оправку, resting against an internal holder of the bearing.
12. Wrap a new nut by hand.
13. Establish a disk of a brake and a support.
14. Tighten a nut of a nave with the set moment (having lowered the car).
15. Lift the car and remove a wheel.
16. Законтрите a nut, having pressed a fillet into a groove on a pin.
17. Grease a cap of a nave with hermetic and напрессуйте a cap on a nave.

18. Establish a wheel and lower the car.