BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
- 13. An electric equipment
   13.1.2. Search of malfunctions
   13.1.3. Safety locks
   13.1.4. The relay
   13.1.5. The breaker of indexes of turn / of the alarm system
   13.1.6. Switches on a steering column
   13.1.7. The ignition lock
   13.1.8. The receiver
   13.1.9. The aerial
   13.1.10. A guard of devices
   13.1.11. Payment SI (the maintenance service index)
   13.1.12. Headlights – replacement of lamps
   13.1.13. Adjustment of headlights
   13.1.14. The headlight case
   13.1.15. Replacement of lamps
   13.1.16. The screen wiper electric motor
   13.1.17. A heater of back glass
   13.1.18. Safety pillows
   13.1.19. Cruise-control system
   13.1.20. The central locking system
   13.1.21. Electric стелокподъемники
   + 13.2. Electroschemes
+ 14. A good advice



13.1.16. The screen wiper electric motor
PERFORMANCE ORDER
1. Disconnect the battery from weight.
The electric motor of a forward screen wiper
2. Hook and uncover lever nuts.
3. Turn away a nut and get a magnet a washer.
4. Hook and get latches and remove a lattice.
5. Turn away screws and nuts and uncover a screen wiper drive on a partition of a motor compartment.
6. Disconnect a socket and draught of a drive.
7. Designate mutual position of draught and the platen, cautiously having hooked a screw-driver, remove draught from the electric motor platen.
8. Turn away three bolts of fastening, raise the electric motor of a screen wiper and remove.
9. Installation is carried out upside-down. If necessary expose the electric motor platen in position of a parking of brushes. For this purpose attach a socket, include and at once switch off a screen wiper.
The electric motor of a back screen wiper
10. Uncover, turn away a nut and remove the lever щеткодержателя from a shaft.
11. Remove the decorative panel and disconnect a socket of conducting and a washer hose.
12. Turn away a nut and remove the electric motor of a cleaner of back glass.
13. Installation is carried out upside-down. If necessary expose the electric motor platen in position of a parking of brushes. For this purpose attach a socket, include and at once switch off a screen wiper.