BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
- 1. The maintenance instruction
   1.1.2. Overall dimensions
   1.1.3. A place of the driver
   1.1.4. The panel of devices
   1.1.5. Keys for the car equipped with an immobilizer
   1.1.6. Стеклоподъемники
   1.1.7. Safety pillows
   1.1.8. The onboard computer
   1.1.9. Indexes
   1.1.10. The voltmeter
   1.1.11. A tachometre
   1.1.12. The counter of the total passed way
   1.1.13. A sound signal
   1.1.14. 3-step automatic transmission
   1.1.15. 4-step automatic transmission
   1.1.16. A mechanical transmission
   1.1.17. A manual brake
   1.1.18. The period обкатки the car
   1.1.19. Fuel
   1.1.20. Threefold каталитический neutralizer
   1.1.21. Engine oil
   1.1.22. Brakes
   1.1.23. Rules of placing of cargo in a luggage carrier
   1.1.24. Start-up of the engine and driving
   1.1.25. Driving receptions
   1.1.26. Trailer towage
   1.1.27. Actions at refusal of start-up of the engine
   1.1.28. An order of start from the additional battery
   1.1.29. If the engine has decayed during movement
   1.1.30. Actions at an engine overheat
   1.1.31. Actions at a wheel puncture
   1.1.32. Towing rules
   1.1.33. Pressure check in tyres
   1.1.34. Check of a condition and replacement of tyres
   1.1.35. Shift of wheels
   1.1.36. Installation of winter tyres and chains
   1.1.37. Check of an external condition of the battery
   1.1.38. Battery gymnastics
   1.1.39. Specifications
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



1.1.30. Actions at an engine overheat
THE GENERAL DATA

The heat of a cooling liquid, loss of capacity by the engine or strong sonorous knocks specify in an engine overheat. In this case the operations procedure is that.

1. Curtail on a roadside, stop and include signals of an emergency stop. Translate the lever in position Р (on automatic transmission) or in neutral position (on mechanical transmission), put the car on a manual brake. Switch off the conditioner (if has been included).

2. If the radiator leaves steam or the liquid stop the engine pours out. After the steam-out will stop open a cowl. If steam-out or a liquid it is not observed, the engine do not stop, be convinced that the fan of system of cooling works. If the fan does not rotate, switch off ignition.

3. Check up survey integrity of a belt of a drive of the pump of a cooling liquid. Check up presence of leaks from a radiator, hoses and from below the engine. Keep in mind that if the conditioner has been included, from conditioner units water running off is supposed.

4. If the belt is torn, or there is a liquid leak immediately stop the engine and call in car-care centre service.

5. If the belt is whole and подтеканий is not present, check up liquid presence in a broad tank. If the tank is empty, add a liquid on the working engine. Fill a tank approximately to the middle.


The prevention

It is not supposed to remove a stopper of a jellied mouth of a radiator on the hot engine. Otherwise it is possible to burn steam pulled out under pressure or a liquid.


6. After cooling of a liquid to normal temperature again check up level in a tank. If level has strongly fallen, in cooling system there is a leak and the car is subject to immediate repair (address in car-care centre).