BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
- 2. Maintenance service
   2.2. Recommended lubricants and liquids
   2.3. Periodicity of service
   2.4. Features of routine maintenance of the car
   2.5. The general data on additional maintenance service
   2.6. Check of level of liquids
   2.7. Check of a condition of tyres and pressure in tyres
   2.8. Oil replacement in the engine and the oil filter
   2.9. Check and restoration of level of a liquid in a wheel
   2.10. Check of level of a liquid in automatic transmission
   2.11. Shift of wheels
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check, adjustment and replacement of belts of a drive of hinged units
   2.14. Check and adjustment of turns and quality of a mix FROM) idling
   2.15. Check of a condition and battery gymnastics
   2.16. Check and replacement of candles
   2.17. Check of high-voltage wires, бегунка and distributor covers
   2.18. Check of level of oil in a manual transmission
   2.19. Check of level of oil in the main transfer
   2.20. Check and adjustment of backlashes in valves (except engine M40)
   2.21. Draught throttle заслонки
   2.22. Replacement of the air filter
   2.23. Check of fuel system
   2.24. Check of system of cooling
   2.25. Exhaust system check
   2.26. Check of shock-absorbers, a suspension bracket and a steering
   2.27. Check of covers of semiaxes
   2.28. Check of brakes
   2.29. Check of brushes of screen wipers
   2.30. Liquid replacement in automatic transmission and the filter
   2.31. Cooling system – replacement of a liquid and washing
   2.32. Replacement of the fuel filter
   2.33. Oil replacement in a manual transmission
   2.34. Oil replacement in картере the main transfer
   2.35. Check of system of catching of steams of gasoline (EVAP-system)
   2.36. Installation of the light alarm system of necessity of servicing
   2.37. Replacement of a gear belt
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



2.16. Check and replacement of candles
THE GENERAL DATA

New candles should correspond to engine type.

PERFORMANCE ORDER
1. Check up a backlash between electrodes of a candle by means of round щупа. Щуп should move between electrodes under small effort.
2. If necessary turn in a lateral electrode. To turn in an electrode follows near to a bend. Candles turn out on one.
3. Disconnect from a candle a wire, keeping for a tip and slightly them turning.
4. Clear and blow compressed air of a platform near to candles and turn out candles.
5. Check up the turned out candle and estimate an engine condition.
6. Grease a carving of a new candle with structure from прихвата on a copper basis, insert and turn by hand, then tighten with the set moment.
7. Check up a condition of wires (subsection 2.17 see), dress a wire on a candle, slightly rotating tips and pressing on them. Repeat procedure for other candles.