BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   - 3.1.2. Specifications
      3.1.3. Kinds of the repair work which is carried out without dismantle of the engine
      3.1.4. An order of installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.5. A cover of a head of cylinders
      3.1.6. A soaking up collector
      3.1.7. A final collector
      3.1.8. Covers of a chain of a drive of a cam-shaft (engine M10)
      3.1.9. A chain and asterisks (engine M10)
      3.1.10. Covers of a gear belt (engines M20 and М40)
      3.1.11. A gear belt and cam-shaft asterisks (engines M20 and М40)
      3.1.12. Forward epiploons
      3.1.13. A head of cylinders
      3.1.14. The pallet
      3.1.15. The oil pump
      3.1.16. A flywheel (a leading disk)
      3.1.17. A back epiploon коленвала
      3.1.18. Engine mount details
   + 3.2. Dismantle and engine major repairs
   + 3.3. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice
Шуйская бязь постельное белье официальный сайт Иваново по материалам www.ивтек𚦉.рф.
Игумнова Оксана подробности на сайте.



3.1.18. Engine mount details

Check and replacement

PERFORMANCE ORDER
1. Will hang out the engine to unload support.
2. Check up presence on support of cracks and отслоения rubbers from a metal basis.
3. Check up an inhaling of bolts of fastening of support, having shaken support the lever. If necessary lower the engine and tighten.
4. On engine M40 check up a condition демпферов for what disconnect them and check up resistance to compression and a stretching.
5. To remove демпфер turn away a bolt. To remove a support, disconnect the battery from weight, lift the car, turn away a nut (it is specified by an arrow), raise the engine, turn away bolts of the bottom arm and get a support. At assemblage grease carving connections by fixing structure.