BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   - 3.1.2. Specifications
      3.1.3. Kinds of the repair work which is carried out without dismantle of the engine
      3.1.4. An order of installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.5. A cover of a head of cylinders
      3.1.6. A soaking up collector
      3.1.7. A final collector
      3.1.8. Covers of a chain of a drive of a cam-shaft (engine M10)
      3.1.9. A chain and asterisks (engine M10)
      3.1.10. Covers of a gear belt (engines M20 and М40)
      3.1.11. A gear belt and cam-shaft asterisks (engines M20 and М40)
      3.1.12. Forward epiploons
      3.1.13. A head of cylinders
      3.1.14. The pallet
      3.1.15. The oil pump
      3.1.16. A flywheel (a leading disk)
      3.1.17. A back epiploon коленвала
      3.1.18. Engine mount details
   + 3.2. Dismantle and engine major repairs
   + 3.3. An engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



3.1.3. Kinds of the repair work which is carried out without dismantle of the engine
THE GENERAL DATA

Without dismantle it is possible to replace linings of soaking up and final collectors, a lining of the oil pallet, a head of the block of cylinders, epiploons of a cranked shaft.

It is possible to remove such units as soaking up and final collectors, the oil pallet, the oil pump, the pump of a cooling liquid, a starter, the generator, the distributor of ignition, a mechanism detail газораспределения, units of fuel system and a head of the block of cylinders.

In extreme cases when there is no necessary equipment, without engine removal it is possible to replace piston rings, pistons, rods and шатунные loose leaves. However, to perform these works without dismantle and full dismantling of the engine extremely it is not recommended, as are required clearing of accompanying details, and also carrying out of preparatory measures on assemblage.

It is necessary to notice that mechanism details газораспределения on engines except М40 are expedient for removing after dismantle of a head of cylinders. Engine M40 cam-shaft acts in film without dismantle of a head after removal of covers of basic necks.