BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1.2. Specifications
   + 3.2. Dismantle and engine major repairs
   - 3.3. An engine electric equipment
      3.3.2. Specifications
      3.3.3. The battery - engine start-up in emergency situations
      3.3.4. Removal and battery installation
      3.3.5. Power cables
      - 3.3.6. Ignition system
         3.3.6.2. Check of system of ignition
         3.3.6.3. Check and installation of the moment of ignition (only for system TCI)
         3.3.6.4. The ignition distributor
         3.3.6.5. The ignition coil
         3.3.6.6. The shaper of impulses and the block of electronic ignition
         3.3.6.7. A backlash in the gauge of the shaper (system TCI)
         3.3.6.8. Gauges of system of ignition
      + 3.3.7. System of a charge of the battery
      + 3.3.8. System of start-up of the engine
      3.3.9. Malfunctions of the generator
      3.3.10. The basic malfunctions of an electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



3.3.6.8. Gauges of system of ignition
THE GENERAL DATA

Gauges of an angle of rotation and speed of rotation коленвала systems Motronic of early release

Socket And – gauges of an angle of rotation

Socket In – gauges of speed of rotation коленвала

1 – a cover of a head of cylinders

Gauges of an angle of rotation and speed of rotation коленвала systems Motronic of late release

Socket And – gauges of an angle of rotation

Socket In – gauges of speed of rotation коленвала

1 – a starter

Check and replacement

PERFORMANCE ORDER
Gauges of an angle of rotation and speed of rotation коленвала
1. Measure resistance between conclusions 1 (a yellow wire) and 2 (a black wire) from outside the gauge which should be 860–1060 Ohm.
2. Measure resistance between conclusions 3 and 2 or 1 which should be 100 clod.
3. If resistance differs, replace the gauge ().
4. For replacement turn away screws and get gauges from nests. Consider that the place of the gauge of an angle of rotation is noted by a letter In, and a place of the gauge of speed of rotation – letter D.
The incorporated gauge of impulses of rotation коленвала (late models)
5. Disconnect sockets.
6. Measure resistance between conclusions 1 (a yellow wire) and 2 (a black wire) from outside the gauge on each socket which should be 500–600 Ohm.

7. If resistance differs, replace the gauge.
8. For replacement turn away a bolt (the gauge fastens on a cover of a gear belt near to a pulley).

9. Get the gauge and replace. The backlash (3) between a head of the gauge (1) and a rotor (2) should be 1,00,3 mm. At replacement expose a backlash brass щупом.