BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Transmissions
   + 8.1.2. Specifications
   - 8.2. Automatic transmission
      8.2.2. Specifications
      8.2.3. Diagnostics of automatic transmission
      8.2.4. Draught of the selector of transmission
      8.2.5. A kick-down-mode cable
      8.2.6. The blocking switch / the switch of a signal of a backing
      8.2.7. Removal and transmission installation
      8.2.8. Epiploons of automatic transmission
      8.2.9. "Automatic machine"
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



8.2.8. Epiploons of automatic transmission Replacement

PERFORMANCE ORDER
Hydrotransformer epiploon
1. Remove transmission and the hydrotransformer (subsection 8.2.7 see).
2. Check up a condition of the plug of the hydrotransformer. If the plug is worn strongly out, replace the hydrotransformer, small damages of the plug try to remove their small skin.
3. Cautiously get an epiploon the adaptation.
4. Grease edges of a new epiploon with a liquid and запрессуйте оправкой, resting against an external part of an epiploon.
5. Establish the hydrotransformer. Track, that it has completely come into gearing with the pump (turn the hydrotransformer, pushing). Further assemblage is carried out upside-down.
Epiploon of the lever of the selector of transmission
6. Lift the car.
7. Remove the lever from a transmission shaft, without disconnecting draught.
8. Cautiously get an epiploon the adaptation or a small screw-driver.
9. Grease edges of a new epiploon with a liquid and запрессуйте оправкой, resting against an external part of an epiploon.
Epiploon of a shaft of transmission
10. Lift the car.
11. Remove exhaust pipes and карданный a shaft (subsection 9.10 see).

12. Unbend контровочные a teeth of a lock washer and turn away a nut. Remove a flange.

13. Grease edges of a new epiploon with a liquid and запрессуйте оправкой, resting against an external part of an epiploon. Dress a flange and tighten a nut, having greased with hermetic its internal surface. Further assemblage is carried out upside-down.

The general instructions

After replacement of any of epiploons check up level трансмиссионной liquids, if necessary restore.