BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
- 9. Coupling
   9.2. Specifications
   9.3. Coupling check
   9.4. The main cylinder of coupling
   9.5. A coupling pedal
   9.6. The blocking switch of coupling
   9.7. The working cylinder of coupling
   9.8. Removal of air from a coupling hydrodrive
   9.9. Coupling details
   9.10. A kardannyj shaft
   9.11. Elastic муфта
   9.12. An average support
   9.13. Kardannye hinges
   9.14. The forward aligning plug
   9.15. The SHRUS карданного a shaft
   9.16. Semiaxes
   9.17. SHRUS and covers
   9.18. Epiploons of a reducer of a back axis
   9.19. A reducer of a back axis
   9.20. An epiploon of a leading gear wheel of a reducer
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



9.12. An average support
THE GENERAL DATA

In deterioration of a support specify the strengthened vibrations карданного a shaft. A support check every time at shaft removal. If the bearing заедает, at its rotation is listened a gnash, or at damage of a rubber holder a support replace.

Check and replacement

PERFORMANCE ORDER
1. Remove карданный a shaft, ослабьте a collar and disunite shaft sections. Remove from forward section of a shaft the rubber plug, a washer and a collar.
2. Check up a condition of the rubber plug, if necessary replace.
3. Remove a lock ring and a cover.
1. A ring
2. A cover
4. Remove from a neck карданного a shaft the bearing of a support with a holder. The stripper should rest against an internal ring of a support.
5. Bearing or holder replacement is separately carried out in workshops.
6. Assemblage is carried out upside-down. Напрессуйте a support so that the support became заподлицо with a cover. Before assemblage clear and grease молибденовой with greasing шлицы (or a bolt of a plug of the hinge). A collar шлицевого connections tighten after installation карданного a shaft on the car.