BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
- 10. Brake system
   10.2. Specifications
   10.3. Antiblocking system (ABS)
   10.4. Колодки disk brakes
   10.5. A support of a disk brake
   10.6. A brake disk
   10.7. Колодки drum-type brakes
   10.8. The main cylinder of brakes
   10.9. The vacuum amplifier of brakes
   10.10. A cable () a manual brake
   10.11. Adjustment of a manual brake
   10.12. The mechanism of a manual brake
   10.13. A brake pedal
   10.14. The switch of a signal of braking
   10.15. Hoses and lines of a hydrodrive of brakes
   10.16. Removal of air from a hydrodrive of brakes
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

10.13. A brake pedal

The prevention

The height of a pedal of a brake should be regulated after removal or replacement of the main cylinder of brakes or the vacuum amplifier. Simultaneously it is necessary to adjust and the switch of a signal of braking.

Adjustment of height of a pedal (the scheme for а/м with the left wheel, on а/м with the right wheel is carried out similarly)

For adjustment of height of a pedal release a counternut (1) and keeping a plug, rotate a pusher (2) until the distance And (between a bottom edge of an overlay of a pedal and a partition of a motor compartment) will not correspond specified in subsection 10.2.

The prevention

On cars with the right wheel adjustment is carried out on the left side of a shaft after the ware box, however distance on the former is removed measured from a pedal.