BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.1.12. Levers of a back suspension bracket Removal and installation

PERFORMANCE ORDER
1. Block forward wheels. Lift a back part of the car and establish on supports, remove wheels.
2. Remove карданный a shaft, or disconnect a shaft from a reducer flange.
3. Disconnect a back hose of a brake from a tube on an arm of the back lever. A hose and a tube muffle.
4. Disconnect a cable of a manual brake (subsection 10.10 see).
5. Disconnect the bottom fastening of the shock-absorber, lower the lever.

6. Turn away a nut of axes of the lever, remove axes and remove the lever.
7. Check up a condition of plugs of axes. In case of detection of cracks, hardenings of rubber or plug anguishes replace, having handed over the lever in a workshop. Diameter of the plug on the one hand is slightly more, this part is designated by a fillet. The party with the big diameter should be turned on the internal lever towards the central part of the car, and on the external lever – from the car.
8. Assemblage is carried out upside-down. At assemblage raise the lever a jack that симитировать real height in the conditions of driving, and tighten nuts of axes with the set moment. Upon termination of remove air from brakes.