BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   - 11.2. A steering
      11.2.2. Tips of helmsmen ятг
      11.2.3. Covers of the steering mechanism
      11.2.4. The steering mechanism
      11.2.5. The hydraulic booster pump
      11.2.6. Removal of air from the wheel hydraulic booster
      11.2.7. A steering wheel
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.2. A steering

11.2.1. Introduction
THE GENERAL DATA

The steering реечного type, consists of a wheel, a column, a shaft with карданным the hinge, the steering mechanism, the hydraulic booster (on a part of cars) and the draughts connecting the steering mechanism with levers of a suspension bracket.

The steering реечное, rotation from a wheel is transferred through карданный the hinge and the steering mechanism. Teeths of a gear wheel of the steering mechanism enter into gearing with teeths рейки which will mix up in a horizontal direction at wheel turn. Рейка it is connected to steering draughts which are in turn connected through tips to rotary levers which are executed at the same time with cases of racks of a suspension bracket. The part of cars is equipped by the wheel hydraulic booster. While in service care of a steering is reduced to check of level of a liquid in the hydraulic booster and tension of a belt of a drive of the pump. However, after considerable run fingers of tips of draughts, карданные hinges of a steering shaft and also rubber муфта карданного a shaft wear out. These details are not under repair and are subject to replacement. Before drawing a conclusion on malfunction of a steering check up pressure in tyres and a condition of tyres. Check up also a condition of the top bearings of racks of a suspension bracket, bearings of naves, and also suspension bracket details.