BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   - 11.2. A steering
      11.2.2. Tips of helmsmen ятг
      11.2.3. Covers of the steering mechanism
      11.2.4. The steering mechanism
      11.2.5. The hydraulic booster pump
      11.2.6. Removal of air from the wheel hydraulic booster
      11.2.7. A steering wheel
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.2.2. Tips of steering draughts Removal and installation

PERFORMANCE ORDER
1. Lift redock of the car and remove wheels.
2. Release a nut and выпрессуйте a finger of a tip of draught a stripper (or beat out easy blows of a hammer). Turn away a nut and disconnect a tip of draught from an eye on the rack case.
3. Release a bolt of a collar of a tip of steering draught. Designate tip position on draught (or measure length of a tip concerning a draught end face) that at assemblage to turn a tip in former position. Turn out a tip from steering draught.
4. Installation is carried out upside-down. Wrap a tip before coincidence of labels, or expose the measured length of a tip.
5. Upon termination of check up corners of installation of wheels in car-care centre.