BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   - 11.2. A steering
      11.2.2. Tips of helmsmen ятг
      11.2.3. Covers of the steering mechanism
      11.2.4. The steering mechanism
      11.2.5. The hydraulic booster pump
      11.2.6. Removal of air from the wheel hydraulic booster
      11.2.7. A steering wheel
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.2.4. The steering mechanism

Removal and installation

PERFORMANCE ORDER
1. Lift redock of the car and remove wheels.
2. Designate position карданного the hinge of a steering shaft that at assemblage not to break its initial installation. Turn away a nut and a bolt of fastening of the bottom part карданного the hinge to the steering mechanism. Turn away a nut and a bolt of fastening of the top part of the hinge, submit the hinge upwards, deduce from gearing with shaft of a gear wheel of the steering mechanism and remove the hinge. Check up a condition of the hinge and deterioration rubber муфты. At detection of signs of deterioration the hinge replace.
3. On cars with the hydraulic booster remove a liquid from a tank.
4. Disconnect hoses from the steering mechanism, having turned away bolts накидных unions, and merge the liquid rests.
5. Disconnect tips of steering draughts.

6. Turn away a nut and bolts of an arm of the steering mechanism.
7. Get the steering mechanism from under the car, without supposing damage of covers.
8. Installation is carried out upside-down. At assemblage combine the labels put before dismantling on карданном the hinge, replace самоподжимные nuts of fastening of the steering mechanism and a lining of unions of hoses of the hydraulic booster. Tighten all connections with the set moments.
9. Lower the car, fill in a liquid in a tank of the hydraulic booster and remove air (subsection 11.2.6 see).

10. Upon termination of check up corners of installation of wheels in car-care centre.