|
1. Wash out a cranked shaft solvent and dry compressed air, clean oil channels, clear necks. |
|
2. Remove надфилем agnails. |
|
3. Check up a condition of necks of a shaft, presence of cracks, hollows, задиров. Check up a roughness of necks, потерев about them a copper coin. If there are traces necks follows перешлифовать. |
| |
4. Measure diameter of necks in several places on a circle and on length and define конусность and ovality. |
| 5. At appreciable damages or if конусность and ovality exceed norm коленвал follows перешлифовать and to replace loose leaves repair. |
|
6. If on necks коленвала under epiploons the deep flute from a working edge of an epiploon was formed, there are scratches or other damages коленвал it is recommended to replace, or проконсультроваться in car-care centre where a neck it is possible to chisel and напрессовать the plug. If development from an epiploon deep even after installation of a new epiploon there will be an oil leak. |
| 7. Check up a condition radical and шатунных loose leaves (subsection 3.2.23 see). |