BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
- 5. Heating and ventilation
   - 5.1.2. The heater and conditioner fan
      5.1.3. The control panel the block a heater - the conditioner
      5.1.4. A heater radiator
   + 5.2. A central air
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

5.1.2. The heater and conditioner fan Removal, check and installation

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. The heater fan is mounted under a dividing partition of a motor compartment and salon and closed by the panel. Turn away forward and top screws of fastening of the panel of the fan.

3. Get conducting, having disconnected (or having cut off) обвязку, and take aside.

4. Remove the panel.

5. Unbutton locks of a tape of fastening of a casing of the fan.

6. Unbutton locks of a tape of fastening of the fan.

7. Disconnect wires and remove the fan.

8. Connect the fan to the battery through a fusible crosspiece. If fan work is accompanied by the raised noise, or speed of rotation low replace the fan electric motor. At removal крыльчатки designate its position on an electric motor shaft not to break balancing.

9. Assemblage is carried out upside-down.

home