BMW 3 series E30

Since 1983-1994 of release

Repair and car operation

+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Transmissions
   - 8.1.2. Specifications
      8.1.3. A check point control lever
      8.1.4. Check point epiploons
      8.1.5. Details of fastening of transmission
      8.1.6. Removal and check point installation
      8.1.7. Manual transmission dismantling
   + 8.2. Automatic transmission
+ 9. Coupling
+ 10. Brake system
+ 11. A running gear
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

8.1.6. Removal and check point installation
1. Disconnect the battery from weight.
2. Remove an exhaust system.
3. Remove карданный a shaft (subsection 9.10 see).
4. Turn away bolts of fastening of arms of the case of the mechanism of change of transfers, disconnect draught of change of transfers.
5. Disconnect wires from gauge VMT, from rotation gauges коленвала and from the switch of a signal of a backing, or remove these gauges.
6. Remove the working cylinder of coupling, without disconnecting a hose. Take the cylinder aside and fix.
7. Will hang out a check point the cart with a jack, turn away a nut of a support of a check point.
8. Cautiously lower the power unit (a check point with the engine) on a cross-beam.
9. Turn away bolts of fastening of a check point to the engine.
10. Cautiously deduce a check point from the engine, without supposing that the primary shaft of a check point perceived unit weight. Lower a check point and roll out the cart from a check point from under the car.
11. Installation is carried out upside-down. Шлицы a primary shaft grease with greasing Microlube GL 261 or equivalent. At check point installation turn коленвал before coincidence шлицов a primary shaft and a frictional disk of coupling. Track, that all washers of bolts of fastening of a check point have been established, otherwise will turn on subsequently bolts extremely difficultly.