BMW 3 series E30

Since 1983-1994 of release

Repair and car operation



BMW E30
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. A running gear
   11.1.10. Back springs
   11.1.11. A bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. The stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. The suspension bracket lever
   11.1.5. A rack of a forward suspension bracket
   11.1.6. Springs or the shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. A nave of a forward wheel and the bearing
   11.1.9. Back shock-absorbers
   + 11.2. A steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



11.1.10. Back springs
THE GENERAL DATA

The prevention

Springs are recommended to be changed in steam.


Removal and installation

PERFORMANCE ORDER
1. Block forward wheels. Lift a back part of the car and establish on supports so that details of a back suspension bracket at its lowering did not touch supports.
2. Disconnect a back part of an exhaust system from a body and lower so that it was possible to get springs at partially removed suspension bracket. Fix выхлорные pipes a wire.
3. Establish under картер a reducer the cart with a jack. With force submit a reducer downwards and fix it, having laid between a body and a reducer a wooden wedge. This measure will allow to prevent breakage of SHRUS of back semiaxes at lowering of levers of a suspension bracket for removal of springs.
4. Establish the cart with a jack under the lever of a back suspension bracket.
5. If in a back suspension bracket the stabilizer of cross-section stability disconnect a bar of the stabilizer from racks is provided, or remove racks of the stabilizer from levers (subsection 11.1.11 see).
6. Pass through a spring a chain and fix a bolt, provide a necessary weak point that the spring could be straightened.
7. Installation is carried out upside-down. Track correctness of installation of a spring at a lever raising.